Target amplification-free detection of urinary microRNA for diabetic nephropathy diagnosis with electrocatalytic reaction.

Diabetic nephropathy (DN) is a serious diabetic complication, usually developed from type II diabetes mellitus (T2DM) and known as type II DN (T2DN). New emerging biomarkers for T2DN are microRNAs (miRNAs) which have been studied for the noninvasive early-stage detection of the disease. In this work, a nucleic acid amplification-free miRNA-124 sensor based on target-induced strand displacement on magnetic beads, and by using methylene blue-loaded silica particles as a label was developed. Measurement methods can be either visual observation, spectrophotometry, or electrochemistry. After incubation and separation of the magnetic particles, a blue-violet solution (564 nm) appeared, depending on the concentration of miRNA displaced. For electrochemical detection, methylene blue on the silica served as a redox mediator for the coupled reaction with ferricyanide in the solution phase. At the electrode surface, ferricyanide was re-reduced to ferrocyanide, and was thus available for further reaction with methylene blue, forming an amplification cycle. After optimization, the total assay time was 60 min, and limits of detection were 1 pM, 6 fM, and 0.65 fM, by the naked eye, spectrophotometry and electrochemistry, respectively. The miRNAs in 42 suspected urine samples from patients suffering from either diabetic nephropathy, diabetes mellitus, or chronic kidney disease were validated by comparing with the droplet digital polymerase chain reaction (ddPCR).

Rapid electrochemical detection of coronavirus SARS-CoV-2.

Coronavirus disease 2019 (COVID-19) is a highly contagious disease caused by severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2). Diagnosis of COVID-19 depends on quantitative reverse transcription PCR (qRT-PCR), which is time-consuming and requires expensive instrumentation. Here, we report an ultrasensitive electrochemical biosensor based on isothermal rolling circle amplification (RCA) for rapid detection of SARS-CoV-2. The assay involves the hybridization of the RCA amplicons with probes that were functionalized with redox active labels that are detectable by an electrochemical biosensor. The one-step sandwich hybridization assay could detect as low as 1 copy/µL of N and S genes, in less than 2 h. Sensor evaluation with 106 clinical samples, including 41 SARS-CoV-2 positive and 9 samples positive for other respiratory viruses, gave a 100% concordance result with qRT-PCR, with complete correlation between the biosensor current signals and quantitation cycle (Cq) values. In summary, this biosensor could be used as an on-site, real-time diagnostic test for COVID-19.

Target Induced-DNA strand displacement reaction using gold nanoparticle labeling for hepatitis E virus detection.

DNA strand displacement is an attractive, enzyme-free target hybridization strategy for nano-biosensing. The target DNA induces a strand displacement reaction by replacing the pre-hybridized strand that is labeled with gold nanoparticles (AuNPs). Thus, the amount of displaced-AuNP-labeled strand is proportional to the amount of target DNA in the sample. The use of a magnetogenosensing technique to isolate the target DNA allows for a simple, one-pot detection approach, which minimizes possible carry-over contamination and pipetting errors. We sought a proof-of-concept for this technology in its ability to detect DNA-equivalent of hepatitis E virus (HEV), which causes acute viral hepatitis for which rapid and simple diagnostic methods remain limited. Signal detection was done via visual observation, spectrophotometry, and electrochemistry. The sensor demonstrated good sensitivity with detection limits of 10 pM (visual), 10 pM (spectrophotometry) and 1 fM (electrochemical). This sensor also exhibited high specificity for real target amplicons and could discriminate between perfect and mismatched sequences. Lyophilized biosensor reagents stored at 4 °C, 25 °C, and outdoor ambient temperature, were stable for up to 90, 50, and 40 days, respectively. The integration of magnetic separation and target DNA-induced strand displacement reaction in a dry reagent form makes the sensing platform easy-to-use and suitable for field settings.